All services (2022-09-22T08:21:31.449Z - 2022-09-21T13:38:03.174Z) 2022-09-22T08:21:31.449Z [wb-mqtt-opcua] WARNING: [OPCUA] userland: AcceptAll Certificate Verification. Any remote certificate will be accepted. 2022-09-22T08:21:31.071Z [init] knxd.service: Failed with result 'exit-code'. 2022-09-22T08:21:29.424Z [] new mount options do not match the existing superblock, will be ignored 2022-09-22T08:21:28.826Z [] NORMAL 2022-09-22T08:21:28.826Z [] RTL871X: RTW_ADAPTIVITY_MODE_ 2022-09-22T08:21:28.825Z [] AUTO, chplan:0x20, Regulation:3,3 2022-09-22T08:21:28.824Z [] RTL871X: RTW_ADAPTIVITY_EN_ 2022-09-22T08:21:28.804Z [] Cannot set file attribute for '/var/log/journal/6887e05d4e7d1e3205cf887b631b581d', value=0x00800000, mask=0x00800000: Operation not supported 2022-09-22T08:21:28.802Z [systemd-tmpfiles-setup] Cannot set file attribute for '/var/log/journal', value=0x00800000, mask=0x00800000: Operation not supported 2022-09-22T08:21:26.810Z [] RTL871X: module init ret=0 2022-09-22T08:21:26.809Z [] RTL871X: rtw_ndev_init(wlan1) 2022-09-22T08:21:26.809Z [] RTL871X: rtw_ndev_init(wlan0) 2022-09-22T08:21:26.585Z [] RTL871X: rtl8723bu BT-Coex version = BTCOEX20140507-4E40 2022-09-22T08:21:26.584Z [] RTL871X: rtl8723bu v4.3.6.11_12942.20141204_BTCOEX20140507-4E40 2022-09-22T08:21:26.584Z [] RTL871X: module init start 2022-09-22T08:21:26.079Z [] platform regulatory.0: Direct firmware load for regulatory.db failed with error -2 2022-09-22T08:21:26.035Z [] bluetooth hci0: Direct firmware load for rtl_bt/rtl8723b_config.bin failed with error -2 2022-09-22T08:21:25.948Z [systemd-udevd] Could not set offload features of eth1: Device or resource busy 2022-09-22T08:21:25.946Z [systemd-udevd] link_config: could not get ethtool features for eth1 2022-09-22T08:21:25.704Z [] usb_phy_generic usb_phy_generic.1.auto: supply vcc not found, using dummy regulator 2022-09-22T08:21:24.411Z [] [/lib/systemd/system/wb-mqtt-w1.service:10] Unknown lvalue 'StartLimitIntervalSec' in section 'Service' 2022-09-22T08:21:24.406Z [] mmc1: host does not support reading read-only switch, assuming write-enable 2022-09-22T08:21:24.373Z [] sun4i-mdio 1c0b080.mdio: supply phy not found, using dummy regulator 2022-09-22T08:21:24.371Z [] lm75 2-0048: supply vs not found, using dummy regulator 2022-09-22T08:21:24.368Z [] axp20x-battery-power-supply axp20x-battery-power-supply: DMA mask not set 2022-09-22T08:21:24.368Z [] axp20x-adc axp22x-adc: DMA mask not set 2022-09-22T08:21:24.355Z [] sun4i-mdio 1c0b080.mdio: supply phy not found, using dummy regulator 2022-09-22T08:21:24.351Z [] sun4i-pinctrl 1c20800.pinctrl: supply vcc-pb not found, using dummy regulator 2022-09-22T08:21:24.333Z [] sun4i-mdio 1c0b080.mdio: supply phy not found, using dummy regulator 2022-09-21T13:38:50.413Z [init] knxd.service: Failed with result 'exit-code'. 2022-09-21T13:38:40.165Z [init] knxd.service: Failed with result 'exit-code'. 2022-09-21T13:38:29.917Z [init] knxd.service: Failed with result 'exit-code'. 2022-09-21T13:38:23.837Z [] RTL871X: assoc success 2022-09-21T13:38:23.155Z [] RTL871X: nolinked power save leave 2022-09-21T13:38:22.513Z [] NORMAL 2022-09-21T13:38:22.513Z [] RTL871X: RTW_ADAPTIVITY_MODE_ 2022-09-21T13:38:22.513Z [] AUTO, chplan:0x20, Regulation:3,3 2022-09-21T13:38:22.512Z [] RTL871X: RTW_ADAPTIVITY_EN_ 2022-09-21T13:38:21.565Z [] process '/sbin/netplugd' started with executable stack 2022-09-21T13:38:19.630Z [init] knxd.service: Failed with result 'exit-code'. 2022-09-21T13:38:15.630Z [] dwmac-sun8i 1c50000.ethernet eth1: PTP not supported by HW 2022-09-21T13:38:11.272Z [wb-mqtt-opcua] WARNING: [OPCUA] server: AccessControl: Unconfigured AccessControl. Users have all permissions. 2022-09-21T13:38:11.272Z [wb-mqtt-opcua] WARNING: [OPCUA] userland: AcceptAll Certificate Verification. Any remote certificate will be accepted. 2022-09-21T13:38:10.155Z [] RTL871X: nolinked power save enter 2022-09-21T13:38:10.005Z [] new mount options do not match the existing superblock, will be ignored 2022-09-21T13:38:09.332Z [] Cannot set file attribute for '/var/log/journal/6887e05d4e7d1e3205cf887b631b581d', value=0x00800000, mask=0x00800000: Operation not supported 2022-09-21T13:38:09.330Z [] Cannot set file attribute for '/var/log/journal', value=0x00800000, mask=0x00800000: Operation not supported 2022-09-21T13:38:07.466Z [] NORMAL 2022-09-21T13:38:07.465Z [] RTL871X: RTW_ADAPTIVITY_MODE_ 2022-09-21T13:38:07.458Z [] AUTO, chplan:0x20, Regulation:3,3 2022-09-21T13:38:07.457Z [] RTL871X: RTW_ADAPTIVITY_EN_ 2022-09-21T13:38:05.467Z [] RTL871X: module init ret=0 2022-09-21T13:38:05.456Z [] RTL871X: rtw_ndev_init(wlan1) 2022-09-21T13:38:05.455Z [] RTL871X: rtw_ndev_init(wlan0) 2022-09-21T13:38:05.258Z [] RTL871X: rtl8723bu BT-Coex version = BTCOEX20140507-4E40 2022-09-21T13:38:05.258Z [] RTL871X: rtl8723bu v4.3.6.11_12942.20141204_BTCOEX20140507-4E40 2022-09-21T13:38:05.258Z [] RTL871X: module init start 2022-09-21T13:38:04.807Z [] platform regulatory.0: Direct firmware load for regulatory.db failed with error -2 2022-09-21T13:38:04.784Z [] bluetooth hci0: Direct firmware load for rtl_bt/rtl8723b_config.bin failed with error -2 2022-09-21T13:38:04.724Z [systemd-udevd] Could not set offload features of eth1: Device or resource busy 2022-09-21T13:38:04.715Z [systemd-udevd] link_config: could not get ethtool features for eth1 2022-09-21T13:38:04.565Z [] usb_phy_generic usb_phy_generic.1.auto: supply vcc not found, using dummy regulator 2022-09-21T13:38:03.250Z [] [/lib/systemd/system/wb-mqtt-w1.service:10] Unknown lvalue 'StartLimitIntervalSec' in section 'Service' 2022-09-21T13:38:03.214Z [] sun4i-mdio 1c0b080.mdio: supply phy not found, using dummy regulator 2022-09-21T13:38:03.212Z [] lm75 2-0048: supply vs not found, using dummy regulator 2022-09-21T13:38:03.209Z [] axp20x-battery-power-supply axp20x-battery-power-supply: DMA mask not set 2022-09-21T13:38:03.209Z [] axp20x-adc axp22x-adc: DMA mask not set 2022-09-21T13:38:03.195Z [] sun4i-mdio 1c0b080.mdio: supply phy not found, using dummy regulator 2022-09-21T13:38:03.191Z [] sun4i-pinctrl 1c20800.pinctrl: supply vcc-pb not found, using dummy regulator 2022-09-21T13:38:03.174Z [] sun4i-mdio 1c0b080.mdio: supply phy not found, using dummy regulator