U-Boot 2017.03-wb1.3.0-g520058c326 (Jan 18 2022 - 10:56:38 +0000)

CPU:   Freescale i.MX6ULL rev1.1 792 MHz (running at 396 MHz)
CPU:   Industrial temperature grade (-40C to 105C) at 34C
Reset cause: POR
Model: Wiren Board rev. 6.1 (i.MX6UL)
Board: Wiren Board MX6UL
DRAM:  1 GiB
MMC:   FSL_SDHC: 0
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   eth0: ethernet@02188000
Hit any key to stop autoboot:  0
Writing to MMC(0)... done
Checking if there is a USB storage with update file wb6_update.fit
dev: usb1_vbus @ regulator@0
starting USB...
USB0:   USB EHCI 1.00
USB1:   USB EHCI 1.00
scanning bus 0 for devices... 2 USB Device(s) found
scanning bus 1 for devices... EHCI timed out on TD - token=0x80008c80
unable to get device descriptor (error=-1)
1 USB Device(s) found
       scanning usb for storage devices... 1 Storage Device(s) found
  Device 0: Vendor: Sony     Rev: 1.00 Prod: MSAC-UAM1
            Type: Removable Hard Disk
            Capacity: 469.0 MB = 0.4 GB (960512 x 512)
reading wb6_update.fit
** Unable to read file wb6_update.fit **
reading wb6_update_FACTORYRESET.fit
1 bytes read in 19 ms (0 Bytes/s)

##############################
# Detected USB flash drive with update file
# Filename: wb6_update_FACTORYRESET.fit
# Press a FW key if you want to update firmware from this file
# or wait 3 seconds to boot normally.
##############################
USB update procedure start
Checking if ubootenv part is present
## Loading FIT header to 0x82000000 ...
reading wb6_update_FACTORYRESET.fit
## Loading FIT strings to 0x82000028 ...
reading wb6_update_FACTORYRESET.fit
## Loading FIT struct to 0x82000100 ...
reading wb6_update_FACTORYRESET.fit
FAT: Misaligned buffer address (820020c8)
   Skip 7928976 bytes of data
reading wb6_update_FACTORYRESET.fit
FAT: Misaligned buffer address (8200042c)
   Skip 46505 bytes of data
reading wb6_update_FACTORYRESET.fit
FAT: Misaligned buffer address (82000e74)
   Skip 4917 bytes of data
   Skip 174753338 bytes of data
reading wb6_update_FACTORYRESET.fit
** wb6_update_FACTORYRESET.fit shorter than offset + len **
Can't find subimage 'ubootenv'
Extracting kernel
## Loading FIT header to 0x82000000 ...
reading wb6_update_FACTORYRESET.fit
## Loading FIT strings to 0x82000028 ...
reading wb6_update_FACTORYRESET.fit
## Loading FIT struct to 0x82000100 ...
reading wb6_update_FACTORYRESET.fit
FAT: Misaligned buffer address (820020c8)
reading wb6_update_FACTORYRESET.fit

U-Boot SPL 2017.03-wb1.3.0-g520058c326 (Jan 18 2022 - 10:56:38)
DRAM init ok, rows:16, ncs:1, size: 1024MB
.p0_mpdgctrl0   = 0x0114010f
.p0_mpdgctrl1   = 0x0e3f0e3f
.p0_mprddlctl   = 0x3f3f3f40
.p0_mpwrdlctl   = 0x3f3f3633
.p0_mpwldectrl0 = 0x0009000b
.p0_mpwldectrl1 = 0x000c000c
Trying to boot from MMC1
Warning - USDHC2 controller not supporting